View Single Post
  #4  
Old 09-09-2014, 04:46 AM
PTsideshow PTsideshow is offline
Level 10 user
 
Join Date: Dec 2006
Location: Southeast Michigan
Posts: 630
Re: Cutting and bending rebar

Have you thought about using an electrical conduit bender Up here commonly called a "HICKEY". No I have only used one on the smallest sized rebar 3/8"dia. The benders common in assorted sizes I have 1/2" 3/4" and 1" You thread a section of pipe in for a handle and they have worked out all the math in a number of books which should give you a very close approximation of what you what. 45's,90's and off sets
Here are two of mine.


Here is a close up with some of the markings on the head.
This is a pipe vise which has 3 holes and bending jigs built in.

Only thing in using them the vise must be locked with a pipe to the ceiling or over heard beam and the floor to keep it in place, or bolted to the floor.


as each leg has a bolt hole.

It is much easier to use the conduit bender. They aren't expensive around $40.00 or less with out the handles for some over 1" they start to get pricey. Menards,Home Despot and High's sells them in most stores or their web sites
__________________
glen
been there done that !
I am not a lawyer, and never played one on TV!
All the usual
and standard disclaimers apply. Do not try this at home, use only as directed, No warranties express or implied, for the intended use or suggested uses, Wear safety glasses, closed course, professionals only
Reply With Quote